Door Edge Pro Installation Instructions

Installing the Door Edge Pro

1. Cut out the installation template printed on this sheet.Position the "+" over the center of the retracted dead bolt on the door.

2. Fold the template at the dotted lines so it lays flat and level on both the inside and outside of the door.

3. With a pencil, mark the top of the template on both sides of the door.

4. Position one of the Door Edge Pro plates so that the long edge lines up with the edge of the door and the top edge is even with the pencil marks.

5. Holding the Door Edge Pro in place, with a pencil, mark the screw holes on the door. Do this on both sides of the door. Be certain that the Door Edge Pro is positioned properly on both sides of the door when making your screw hole marks.

6. With the door closed, starting on the inside of the door, using a 1/4" drill bit, slowly drill into the door at the penciled screw hole marks. Caution: keep drill level and ONLY DRILL HALF-WAY THROUGH THE DOOR.

7. Repeat step 6. on the outside of the door. Drilled screw holes should now be perfectly aligned through the door.

8. Position one part of the Door Edge Pro on the outside of the door. Insert the 1/2" anchor nut with smooth head (no slot) through the top of the Door Edge Pro plate and into the screw hole in the door.

9. Position the second part of the Door Edge Pro on the inside of the door. Insert the 1-3/4" slotted screw through the top of the Door Edge Pro plate, into the screw hole in the door until it meets with the anchor nut and tighten with a screwdriver.

10. Repeat step 9. on the bottom screw hole of the Door Edge Pro.

Tip on Color Matching

To match the door and trim color, lightly sand all parts and paint.